netlink[ 0.000000] Booting(10)

[ 2.582125] pci 0001:01:00.0: BAR 2: assigned [mem 0x20000000-0x207fffff 64bit]

[ 2.589460] pci 0001:01:00.0: BAR 4: assigned [mem 0x20c00000-0x20cfffff 64bit pref]

[ 2.597231] pci 0001:01:00.0: BAR 0: assigned [mem 0x20800000-0x20807fff 64bit]

[ 2.604567] pci 0001:00:00.0: PCI bridge to [bus 01]

[ 2.609542] pci 0001:00:00.0: bridge window [mem 0x20000000-0x20bfffff]

[ 2.616354] pci 0001:00:00.0: bridge window [mem 0x20c00000-0x20cfffff 64bit pref]

[ 2.740169] pcie_iproc_bcma bcma0:9: PCI host bridge to bus 0002:00

[ 2.746457] pci_bus 0002:00: root bus resource [mem 0x28000000-0x2fffffff]

[ 2.753362] pcie_iproc_bcma bcma0:9: PHY or data link is INACTIVE!

[ 2.759553] pcie_iproc_bcma bcma0:9: no PCIe EP device detected

[ 2.765535] pcie_iproc_bcma bcma0:9: PCIe controller setup failed

[ 2.773241] bcm47xx-wdt bcm47xx-wdt.0: BCM47xx Watchdog Timer enabled (30 seconds, Software Timer)

[ 2.782258] bcma: bus0: Bus registered

[ 2.786605] NET: Registered protocol family 10

[ 2.792012] NET: Registered protocol family 17

[ 2.796510] 8021q: 802.1Q VLAN Support v1.8

[ 2.800787] Registering SWP/SWPB emulation handler

[ 2.807367] UBI: auto-attach mtd5

[ 2.810739] ubi0: attaching mtd5

[ 3.436449] ubi0: scanning is finished

[ 3.448977] ubi0: attached mtd5 (name "ubi", size 120 MiB)

[ 3.454506] ubi0: PEB size: 131072 bytes (128 KiB), LEB size: 126976 bytes

[ 3.461397] ubi0: min./max. I/O unit sizes: 2048/2048, sub-page size 2048

[ 3.468198] ubi0: VID header offset: 2048 (aligned 2048), data offset: 4096

本文来自电脑杂谈，转载请注明本文网址：
https://www.pc-fly.com/a/jisuanjixue/article-64675-10.html