critical section 中断唤醒系统流程(6)

4)resume_irqs继续调用，最终会enable所有在susoend中关闭的irq。

5)check_irq_resend才是真正触发你注册的中断handle执行的真凶。

check_irq_resend代码如下:

void check_irq_resend(struct irq_desc *desc)

{

/*

* We do not resend level type interrupts. Level type

* interrupts are resent by hardware when they are still

* active. Clear the pending bit so suspend/resume does not

* get confused.

*/

if (irq_settings_is_level(desc)) {

desc->istate &= ~IRQS_PENDING;

return;

}

if (desc->istate & IRQS_REPLAY)

return;

if (desc->istate & IRQS_PENDING) {

desc->istate &= ~IRQS_PENDING;

desc->istate |= IRQS_REPLAY;

if (!desc->irq_data.chip->irq_retrigger ||

!desc->irq_data.chip->irq_retrigger(&desc->irq_data)) {

unsigned int irq = irq_desc_get_irq(desc);

/* Set it pending and activate the softirq: */

set_bit(irq, irqs_resend);

tasklet_schedule(&resend_tasklet);

}

}

}

由于在之前分析已经设置了IRQS_PENDING flag，因此这里会tasklet_schedule(&resend_tasklet)并且置位irqs_resend变量中相应的bit位，代表软中断触发。然后就开始tasklet_schedule最终会唤醒ksoftirqd线程，在ksoftirqd线程中会调用你注册的中断handle，毕竟ksoftirqd线程优先级很高，所以很快就会调度了。具体调用过程可以参考wowo的softirq和tasklet文章。这里我们也可以得出中断handle执行的上下文环境是软中断上下文的结论。当然我们还是有必要分析一下tasklet最后一步resend_irqs()函数的作用，代码如下：

/* Bitmap to handle software resend of interrupts: */

static DECLARE_BITMAP(irqs_resend, IRQ_BITMAP_BITS);

/*

* Run software resends of IRQ‘s

*/

static void resend_irqs(unsigned long arg)

{

struct irq_desc *desc;

int irq;

while (!bitmap_empty(irqs_resend, nr_irqs)) {

irq = find_first_bit(irqs_resend, nr_irqs);

本文来自电脑杂谈，转载请注明本文网址：
https://www.pc-fly.com/a/jisuanjixue/article-77051-6.html