srvcc和csfb_csfb_srvcc(2)

At this point, the scenario file can be used for the SRVCC test. Phase 1 is only required to create the mobility message, which is only subject to the change of the 8960 configuration.

Phase 2 - SRVCC Execution

Using the scenario file created in Phase 1.

Preset the test set and PXT and perform the pre-test setupStart IMS voice call and verify audio is heard on both sidesConfigure the SRVCC SRVCC EPS Bearer ID on the test setConfigure the UE specific settings on the test set. Same with the operation in Phase 1Setup the test set for an inbound SRVCC handover. The Call Status should switch to HandoverCause the SRVCC message created in Phase 1 to be sent. This can be achieved by manually sending the command or altering power levels if the PXT scenario file sends it in response to measurement reports.The UE moves to the UTRAN and continues the voice call

本文来自电脑杂谈，转载请注明本文网址：
http://www.pc-fly.com/a/tongxinshuyu/article-32541-2.html